Cooper Lighting DE621 Indoor Furnishings User Manual


 
317
TRACK LIGHTING Four Circuit
COOPER LIGHTING
HALO
®
L900 Outlet Box Cover
Can be used at any electrical feed connection
point (Live, Straight, L, T or X). Size: 5” sq.
Screws included.
Finishes: White (P), Black (MB)
L923 Straight Connector
To connect two track sections end-to-end. May
be used as feed point.
Finishes: White (P), Black (MB)
L925 T Connector
To connect three track sections into a T
Configuration. May be used as feed point.
Finishes: White (P), Black (MB)
L954 Pendant Kit
To suspend track from the ceiling. Order as
follows: 2 kits for 2’ Trac; 2 kits for 4’ Trac; 3 kits
for 8’ Trac; 4 kits for 12’ Trac. 18” threaded steel
stem, one canopy and mounting hardware.
Finishes: White (P), Black (MB)
L982 Conduit Connector
A Live End Connector for use with surface
conduit. Designed to accept standard 3/4” trade
size conduit fitting (not supplied).
Finishes: White (P), Black (MB)
L983 T-Bar Attachment Clip
Allows track to be attached to inverted tee
ceiling. Order as follows: 2 kits for 2’ Trac; 2 kits
for 4’ Trac; 3 kits for 8’ Trac and 4 kits for 12’ Trac.
L921 Live End Connector
To start a run.
Finishes: White (P), Black (MB)
L924 L Connector
Connects two track sections at a right angle.
May be used as feed point.
Finishes: White (P), Black (MB)
L926 X Connector
To connect four track sections into a cross
configuration. May be used as feed point.
Finishes: White (P), Black (MB)
L963 Single-Circuit to Four-Circuit
Convertor with Switch
Allows any Halo Power-Trac lampholder
(except solid state low voltage and L3218, L3232,
L3239, L5120, L5130, L5138) to be used with Four
Circuit Trac. One converter is required for each
Power-Trac lampholder used. This adapter is
designed to fit into the trac in either of two
directions. Facing in one direction, it makes
contact with circuits 1 and 2, with a 3-position
switch (on-off-on) used to select the desired
circuit. To connect the fixture with circuits 3 or 4,
the adapter is removed from the trac, turned
180°, and is then re-inserted into the trac.
L963 is rated at 500 watts maximum.
Finishes: White (P), Black (MB)
DE621 Dead End
Replacement Dead Ends for Four-Circuit track (6
included)
Finishes: White (P), Black (MB)