Filter
Top Products
10
Majestic Fireplaces® UVC / UVS Vent-Free Heaters
20000135
Glass Information
(UVC Only)
Only glass approved by CFM Specialty
Home Products should be used on this
fireplace.
• The use of any non-approved replacement glass will
void all product warranties.
• Care must be taken to avoid breakage of the glass.
• Do not operate appliance with glass front re-
moved, cracked or broken.
• Replacement glass (complete with gasket) is
available through your CFM Specialty Home
Products dealer and should only be installed by
a licensed qualified service person.
Louvre Removal
To remove the top
louvre (grille), lift lou-
vre up and then out.
(Fig. 12)
cleaner and warm water (we recommend gas fireplace
glass cleaner). After that the glass should be cleaned
two or three times during each heating season depend-
ing on the circumstances present.
Clean glass after first two weeks of opera
-
tion.
Log Installation
Refer to Figures 14 and 15 for correct log placement.
1. Remove window frame assembly. (See "Window
Frame Assembly" section)
2. Remove logs from packaging.
As with all plastic - these are not toys and
should be kept away from children and
infants.
3. Place rear log (BE8 or BF10) on rear bracket (ensure
log is seated properly, leveled and centered to the
unit), so it will not move from side to side and it is
firmly positioned on the bracket.
4. Place front left log (BE6 or BF8) on top of burner, left
side. Use log's bottom holes to locate it onto the left
bracket log locator studs.
5. Place front right log (BE7 or BF9) on top of burner,
right side. Use log's bottom holes to locate it onto
the left bracket log locator studs.
6. Place ember material on top of burner. (See "Ember
Material Placement" section).
Operating Instructions
FP444
Fig. 12 Louvre installation and
removal.
1.
2.
Grille
(Louvre)
Window Frame
Assembly
FP1000
install glass
12/99
Fig. 13 Window Frame installation and removal.
DV34-2
Glass removal
12/99
Clamps
Fireplace
Front
Window
Frame As-
sembly
Pull
Clamp
Hook
Push
Clamp
Hook
DV34-2
FP1000
Window
Frame
Assembly
Window Frame Assembly Removal
1. Shut off gas. (See Lighting Instructions)
2. Let the unit cool if it has been operating.
3. Remove top louvre. (See Top Louvre Removal)
4. Open the bottom louvre assembly.
5. Release the two clamps at the bottom of the window
frame by pulling down on the clamp handles.
6. Lift off the window frame assembly as shown in
Figure 13.
7. To reinstall window frame assembly follow the above
procedure in reverse. (Fig. 13)
Glass Cleaning
It will be necessary to clean the glass periodically. Dur-
ing start-up, condensation, which is normal, forms on
the inside of the glass and causes lint, dust and other
airborne particles to cling to the glass surface. Also,
initial paint curing may deposit a slight film on the glass.
It is therefore recommended that the glass be cleaned
two or three times with anon-ammonia household