Coleman HOT WATER 2300 Water Heater User Manual


 
Troubleshooting Guide
Symptom Problem Solution
Yellow battery Low Light
on during operation Battery voltage low Charge battery
Battery defective Replace battery (refer to maintenance section for
instructions)
Burner will not light Propane cylinder empty Replace cylinder
Propane cylinder frosted Replace cylinder and reuse after thawing
Electronic circuit defective
Send to Coleman Service Center
Low or no water flow Battery lead disconnected Remove battery cover & reinstall lead
(less than 1 gallon per
minute) Pump is not positioned properly Rotate pump so “THIS SIDE UP” is facing upward
Water container out of water Fill water container
Pump screen clogged Remove and clean screen
Hose bent or kinked Straighten hose
Pump unplugged Make sure the black wire is plugged into back of heater
Water bubble in hose Drain hose completely
Water leak at pump to
container Fitting cross-threaded Remove pump and reconnect to water container
Hose turns white or
discolors inside Calcium buildup Clean heater (refer to page 6 for cleaning instructions)
Water leaking from
inside heater
Defective seal or break Send to authorized Coleman Service Center
Service
Repairs to gas passages, electrical circuitry and associated components should be done only by Coleman or an authorized
service person.
Owner repair and service should be limited and performed only to the following:
Cleaning
Propane cylinder leak checks and cylinder replacement
Battery replacement
Pump & pump hose replacement
Repair to doors: battery compartment door & battery charger compartment door.
For Coleman authorized service, call 1-800-835-3278 – TDD 316-832-8707
.
9