Filter
Top Products
To Set Up cont.
• Installation of propane cylinder in Hot Water on Demand
TM
.
• Use standard propane cylinders made for camping products.
• Do not use 14.1oz cylinders normally used for hand torches.
• Do not use MAPP gas cylinders or any other fuel except propane.
• Make sure the control knob is turned “OFF”.
• Push in on the propane access door latch that is located on the left side of the door and swing door to opened position.
• Remove cap from propane cylinder but do not discard.
• While holding the propane cylinder upright, attach it to
the REGULATOR located inside the door by turning
clockwise. Be careful not to cross-thread, hand tighten
only.
Open the Propane Access Door.
Remove propane cap. Install the propane cylinder.
• Check for Propane Leaks
• Make 2 to 3 oz. of leak check solution (one part liquid dishwashing
detergent and three parts water).
• Apply several drops of solution at the connection between the propane
cylinder and the regulator. (Fig. 2)
• Bubbles indicate a leak.
• Check that the connection is not cross-threaded and that it is tight.
• Perform another leak check. If there is still a leak, remove the cylinder
and contact Coleman for services or repair.
WARNING
• Perform leak test outdoors.
• Extinguish all open flames.
• NEVER leak test when smoking.
• Do not use Hot Water on Demand
TM
until connection has been
leak tested and does not leak.
5
WARNING
• If using refillable propane cylinder, the LP-gas cylinder(s) must be
constructed and marked in accordance with the specifications for
LP-gas cylinders of the U.S. Department of Transportation or
Transport Canada, CAN/CSA B339. Use only Coleman® acces-
sories or parts. During heater set-up, check all hoses and fittings
for leaks using soapy water. Never use a flame. Always keep refill-
able cylinders outdoors, never inside house, camper or tent.
Fig. 2