Filter
Top Products
5
Leak Check
WARNING
• Perform leak test outdoors.
• Extinguish all open flames.
• NEVER leak test when smoking.
• Do not use the outdoor stove until connection has been leak test-
ed and does not leak.
■ Check the connection
between the cylinder and
the regulator with soapy
water. Bubbles indicate a
leak. Check that the con-
nection is not cross-thread-
ed and that it is tight.
Perform another leak check.
If there is still a leak,
remove the cylinder and
contact Coleman for service
or repairs.
Leak
Check
To Set Up cont.
Using the Optional Griddle
(Sold Separately)
■ Place griddle at either
end of the stove with
drain slot at end of stove.
Leak Check cont.
Step 1
NOTE: Use Coleman 16.4 oz disposable propane cylinders. The LP
gas cylinder(s) used with stoves must be constructed and marked in
accordance with the specifications for LP-gas cylinders of the U.S.
Department of Transportation or
Transport Canada
, CAN/CSA B339,
Cylinders, Spheres and Tubes for the Transportation of Dangerous
Goods.
■ Place the grill onto the
stove.
■ Make sure burner valve is
off.
■ Remove plastic cap from
top of propane cylinder. Save
cap for use in storing. Screw
propane cylinder into REGU-
LATOR. Be careful not to
cross-thread. HAND TIGHTEN
only.
Step 2
Step 3
■ The regulator uses a
threaded fitting to attach
to the stove. It is neces-
sary to hold the stove to
make sure the fitting is
seated. Align the regula-
tor to the fuel tube on
the rear of the stove and
push on. Screw on the
outer threaded sleeve
in a clockwise direction
until tight.
■ Never operate stove with
propane cylinder in an invert-
ed position.
Step 4
■ Proper location of the burner with respect to the orifice is important.
To verify the proper installation of the burner tube, remove the water
pan and look downward through the opening. The burner tube must
be located over the brass orifice fitting.
Brass
Orifice
Fitting
Burner Tube
Using the Propane Cylinder Support
■ If using the stove on a table-top, allow the base of the propane cylin-
der to rest on the surface of the table-top. Do not use the propane
cylinder support.
■ If using the stove with its legs, pull up and rotate bottle support
assembly until support wire is perpendicular to stove case.
Propane
Cylinder
Support
Burner and Orifice
■ Check and clean the
burner/venturi tubes for
insects and insect nests. A
clogged tube can lead to a fire
beneath the appliance.