Filter
Top Products
8
Inspire Electric Fireplace
10009472
Operating Instructions
Heater Operation
The heater is operated by the remote control handset.
A master ON/OFF switch is located under the appliance
on the left hand side. This is used to turn the appliance
completely off.
All further operations are controlled by using the remote
control handset. (Fig. 5)
1. Ensure the appliance is plugged in and switched on.
2. To turn the fire on, press the fire on/flame effect but-
ton.
3. For low heat, ensure the flame effect is on and press
the low heat button once. To turn the low heat off,
press the low heat button a second time. The fire will
now be running with flame effect only.
4. For high heat, ensure the flame effect and low heat
settings have been switched on. Press the high
heat button. The high heat button will only work if
the flame effect and low heat have already been
switched on. To turn high heat off, press the high
heat button a second time. The fire will now be run-
ning with low heat.
5. To place the fire in a standby mode at any time,
press the fire off button.
Switch Marking Operation
Master ON/OFF O I On/Off. Depress to I,
this supplies power to the
appliance and places it in
a standby mode.
Fire On/Flame
Effect Only
Low Heat
On/Off
Fire Off
High Heat
On/Off
FP1639
Fig. 5 Remote control handset.
NOTE: The frequency setting of the RF transmitter label
affixed on the lower left front of the unit must match the
dial setting on the rear of the remote control handset.
Frequency Setting Information
Dial Set Switch Set
A ON/ON/ON/ON
B ON/ON/ON/OFF
C ON/ON/OFF/ON
D ON/ON/OFF/OFF
E ON/OFF/ON/ON
F ON/OFF/ON/OFF
G ON/OFF/OFF/ON
H ON/OFF/OFF/OFF
I OFF/ON/ON/ON
J OFF/ON/ON/OFF
K OFF/ON/OFF/ON
L OFF/ON/OFF/OFF
M OFF/OFF/ON/ON
N OFF/OFF/ON/OFF
O OFF/OFF/OFF/ON
P OFF/OFF/OFF/OFF
ON
1 2 3 4
Example of Frequency Setting
Switch Set = ON ON OFF ON
Dial Set = C