Filter
Top Products
2.1. Mounting TV with a curved back or obstruction
Note: The plastic cover (shown in dotted lines) is only provided on model number TP150B; but NOT on model
number TC105B.
Note: Most flat screen TVs are provided with Digital Optical Audio Output on the back of the TV. If your TV has
one, locate the Digital Optical Audio Output – as this will be used later.
Position the motorized bracket [02] and the non-motorized bracket [03] on the back of the TV so that the
bottom of the two brackets [02] and [03] are at least 1.5 in. (38.1 mm) from the bottom of the TV.
Select the correct screw [19, 20, 21, 22] by hand threading them into the threaded insert on the back of the TV.
Stop immediately if you encounter any resistance.
Use washer [29] with screws [19, 20] only.
If the distance between the two threaded inserts on the back of the TV is greater than 31.5 inches (800mm),
then the distance between the two brackets [02] and [03] may be too wide and they may not fit onto the wall
brackets [01].
OPT
12