Filter
Top Products
Installation Instructions RMF1
7
Figure 3
Figure 4
Figure 5
Figure 6
Wall Plate Installation
Lag Bolt Installation Instructions
To Install wall plate:
WARNING: It is the responsibility of the installer to verify
that the structure to which the mount is anchored will safely
support five times the combined load of all attached
components and equipment.
1. Determine a suitable mounting location and lift the wall plate
(10) into place.
2. Using a small nail or screw (not provided) in the center hole,
lightly support the wall plate at the mounting location.
3. Level the wall plate (10) and drill pilot holes for anchoring
the wall plate into wood studs using a 15/64” drill bit.
4. Using four 5/16” lag bolts (210) and 5/16” washers (220),
install the wall plate on the wall.
5. Slide the latches to the outside.
Display Installation
To Install display:
1. Place the display on the wall plate (10) by hooking the
hooks of the brackets (20 and 30) in the top of the wall plate
(see Figure 7).
2. Secure the display by sliding the latches, one on each side,
inward. (See Figure 7)
3. If desired, install self tapping screws (230) and/or
padlocks (not provided) for additional security.
(See Figure 7)
4. Tilt the display up or down as desired.
5. Tighten knobs to achieve the desired tension.
SPACER
(IF NECESSARY)
SHOULDER WASHER
STEEL WASHER
SCREW
CENTERLINE OF SCREEN