Filter
Top Products
Model: PSH-2000 Installation Instructions
8
INSTALL DISPLAY
WARNING: Display is very heavy! Ensure display can
be safely lifted and maneuvered as required to install
on mount. Failure to take adequate precautions can
result in serious personal injury or damage to
equipment!
1. Ensure latches (40) are in fully open (raised) positions
(See Figure 6).
2. Note button openings to be used on each bracket (20)
when installing display (See Figure 14).
Figure 14: Mounting Holes
3. Lift and maneuver display such that all buttons (90) fit
into button openings on brackets (20). Lower display
firmly into place. Ensure each button (90) has fully
seated in its button opening.
4. Using Phillips screwdriver, tighten screw (70) until
latch (40) slides into closed position (See Figure 15).
Figure 15: Closed Latch
5. Repeat for second latch (40).
6. Connect cables to display as required.
REMOVE DISPLAY
WARNING: Display is very heavy! Ensure display can
be safely lifted and maneuvered as required to remove
from mount. Failure to take adequate precautions can
result in serious personal injury or damage to
equipment!
1. Disconnect all cables from display.
2. Using Phillips screwdriver, fully remove screw (70)
from threaded hole in bracket (20) (See Figure 6).
3. Re-install screw (70) into threaded hole in latch (40).
Turn screw (70) until latch (40) slides into fully open
position.
4. Repeat for second latch (40).
5. Lift and maneuver display mounting buttons (90) out
of button openings.
Four
Button
Installation
Six
Button
Installation
(20)
(70)
(40)