Filter
Top Products
Model: PSH-2000 Installation Instructions
6
INSTALL MOUNT TO WALL
1. Determine approximate mounting location, keeping in
mind the display size.
WARNING: The mount must be installed on two or
three wood studs (or other equivalent vertical or
horizontal supporting framework). Do not mount to
single wood studs. Failure to properly install unit can
result in serious personal injury or damage to
equipment!
2. Use a stud sensor to locate applicable wood studs.
Mark locations with a pencil.
3. Level mount at desired height per one of the
configurations below:
NOTE: Either configuration below provides ± 2" of lateral
shift.
• 16" on center studs: The mount is approximately
centered between two or three studs as shown
(See Figure 8).
• 24" on center studs: The mount is offset to the left
or right of center between two studs as shown
(See Figure 9).
Figure 8: 16" On Center Stud Installation
Figure 9: 24" On Center Installation
4. Using mount as a template, mark the location of the
pilot holes. Ensure the following:
• Marks are in the center of wood studs.
• 8 pilot holes are marked (one in each slot).
NOTE: For 16" on center, 3 stud installation: Lag bolts
and washers on center stud are optional.
5. Drill pilot holes using a 7/32" drill bit. Ensure pilot
holes are straight.
6. Using 1/2" wrench, install eight 5/16" x 2 ½" lag bolts
and eight 5/16" washers through mounting holes and
into pilot holes. Tighten all lag bolts.
NOTE: Lag bolts and washers are not supplied.
Centered between 3 studs
Centered between 2 studs
Lag Bolt &
(8 Places)
Washer
Lag Bolt &
(8 Places)
Washer
Left of center installation
Right of center installation
Lag Bolt & Washer
(8 Places)
Lag Bolt &
(8 Places)
Washer