Filter
Top Products
Installation Instructions MSA/MTA Series
9
Figure 7
Attaching Screen to Wall Mount
1. Adjust Velcro® pull strap (if necessary) so it does not
extend beyond bottom of screen. (See Figure 8)
NOTE: Do NOT allow both interface brackets to be located on
same side of wall bracket. (See Figure 8)
NOTE: NEVER place both interface brackets to one side of the
wall mount center line! (See Figure 8)
Figure 8
2. Hang top hook of interface brackets onto the top bar of the
mount. (See Figure 9)
NOTE: The screen initially installs into the "kickstand mode" to
allow easy cable access.
3. Slide screen and bars to desired viewing position.
4. Route cables between wall and bars.
CAUTION: PINCH POINTS! Keep fingers, hands and
cables out of pinch point areas.
3d
3e
Knobs to outside
of brackets
Both interface brackets must NEVER be located
to one side of the wall brackets!
Pullstraps
NEVER place both interface brackets to one
side of the wall mount center line (CL)!
Center Line (CL)