Filter
Top Products
Model: KTP-Series Installation Instructions
6
Figure 13: Reinstall End Lock(s)
ADJUSTMENTS
Display Adjustment
The KTP Series mount allows horizontal, pitch, and
rotational adjustment of each display.
The KTP Series mount also allows a full 360 deg. of
display rotation with a maximum pitch range of 15° up
and 15° down.
Display Horizontal Position Adjustment
To adjust display horizontal position:
1. Loosen Centris bracket rear adjustment knob (see
Figure 14).
2. Slide Centris bracket with display left or right until
properly positioned on array rail.
3. Tighten Centris bracket rear adjustmnent knob.
Figure 14: Display Horizontal Adjustment
Display Pitch and Roll Adjustment
To adjust display pitch or roll position:
1. Loosen Centris bracket front adjustment knob.
(see Figure 15)
2. Tilt display up or down, or adjust display roll left or
right until properly positioned.
3. Tighten Centris bracket front adjustmnent knob.
Figure 15: Display Pitch and Roll Adjustment
CABLE MANAGEMENT
The KTP Series mount includes cable management
features used to properly route and secure display
cables.
To use the cable management features:
1. Connect cables to display.
2. Route cables through cable clips on array rail.
3. Route cables down pole and away from mount and
secure to pole using sheath (80).
Figure 16: Cable Management
End Lock
End Lock Retaining Screw
Centris Head
(20, 30)
Horizontal
Adjustment
Knob
Pitch/Roll
Adjustment
Knob
(80)
Cable Clips