Filter
Top Products
Installation Instructions FSA/KSA-1004
4
INSTALLATION
Adding a lift arm modifies your mount configuration. This
procedure applies to most small flat panel displays,
particularly those with a pivot or swing arm, whether wall
mount or desk mount.
Removing the Display from the Mount
To remove the display from its mount, perform the
following steps:
NOTE: Do not remove the four screws (not shown) that
attach the display to the interface bracket.
1. Disconnect the power/audio/video cables from the
display (not shown).
2. Remove the cap screw, washers, pivot pin, and
retaining nut from the display end of the mount.
Refer to Figure 2. Separate the display from the
mount.
3. To remove the pivot pin (see Figure 2) from the other
end, do the following:
a. If the mount is a pivot/pitch wall mount, remove
the attaching hardware from the display.
b. If the mount is wall mounted, desk mounted, or
has more than one swing arm, remove the
attaching hardware from the arm closest to the
display.
NOTE: The two button head cap screws removed from
the mount will be replaced with longer screws
when the lift arm is installed.
NOTE: Keep the pivot pin removed in step 2. This part
will be used again when the lift arm is installed.
Figure 2. Single Swing Arm (FWS-110) — Example
Display Mount Parts — Typical
PART NAME QTY
SCREW, CAP 2
WASHER, FLAT 4
SMALL WASHER, NYLON 2
LARGE WASHER, NYLON 2
NUT, NYLOCK 2
Pivot Pin
Cap screw
Large
Washer
Small
Washer
Nut
Flat Washers