Filter
Top Products
Installation Instructions FSA/KSA-1004
2
CONTENTS
PARTS.......................................................................3
PARTS LIST ..............................................................3
INSTALLATION..........................................................4
Removing the Display from the Mount.....................4
Installing the Lift Arm ..............................................5
Installing base end of lift arm...............................5
Installing display end of lift arm............................5
Adjusting Lateral Movement....................................6
Adjusting Lift Arm Tension ......................................6
Cable Management ................................................Error! Bookmark not defined.
IMPORTANT WARNINGS and CAUTIONS!
WARNING A WARNING alerts you to the possibility of serious injury or death if you do not follow
the instructions.
CAUTION A CAUTION alerts you to the possibility of damage or destruction of equipment if you do not
follow the corresponding instructions.
WARNING
Improper installation can result in serious personal injury! Make sure that the
mounting surface can support a redundant weight factor five times the total weight of
the equipment: if not, reinforce the mounting surface structural members before
installing the FSA/KSA-1004.
WARNING
Be aware of the potential for personal injury or damage to the unit if it is not
adequately mounted.
WARNING
The installer is responsible for verifying that the mounting surface to which the
FSA/KSA-1004 is anchored will safely support the combined load of all attached
components or other equipment.
WARNING
The combined weight of the display placed on the FSA/KSA-1004 must not exceed 25
lbs. (11.3kg), the maximum load capacity of the mount.
WARNING
Watch for pinch points. Do not put your fingers between movable parts.
WARNING
Make sure the mount is correctly oriented.
WARNING
When using an OFB and adding an additional arm to an existing mount, the total
number of arms on the mount cannot exceed two arms.
CAUTION
Check the unit for shipping damage before you begin the installation.
CAUTION
Over-tightening mounting screws may damage your display.
TOOLS REQUIRED FOR
INSTALLATION
5/32” Hex key wrench (provided)
3/16” Hex Key wrench (provided)
NOTE: Other tools may be required depending on the
method of installation.