Chicago Electric 97677 Vacuum Cleaner User Manual


 
Page 10SKU 97677 For technical questions, please call 1-800-444-3353.
Wet Vacuuming:
1.

Cover (9).
(See Figure A, and Assy. Diagram.)
Snap the Foam Filter (85) over 2.
the Filter Cage (84). NOTE: The

underside of the Upper Cover (9).
(See Figure A.)
Replace the Upper Cover (9), and 3.


(See Figure A, and Assy. Diagram.)
Attach the Suction Hose (50) to the 4.
Intake Port (49). (See Figure A.)
Extend the Telescopic Suction Tube 5.
(82), and attach it to the end of the
Suction Hose (50). (See Figure A.)
Attach either the accessory Wet & 6.
Dry Brush (83), Crevice Nozzle (86),
or Furniture Brush (87) to the end of
the Telescopic Suction Tube (82).
(See Figure A.)
Plug the Power Cord (11) into the 7.
nearest 120 volt, grounded, electrical
outlet.
Turn the Switch Knob (80) to its 8.
“ON” position to start the Wet/Dry
Vacuum. (See Figure A.)
9.
by sliding the Air Flow Adjusting Knob
(67) to the left or right.
(See Figure A.)
Guide the accessory Wet & Dry 10.
Brush (83), Crevice Nozzle (86),
Furniture Brush (87) with slight
pressure, slowly and evenly, over the
dirty water. (See Figure A.)
IMPORTANT: 11. The Wet/Dry Vacuum
features Safety Float (63) which will
automatically stops the vacuuming
when the Tank (35) is full (as
indicated when the Motor speed
increases). If this happens, turn off
the Switch Knob (80) and unplug the
unit from its electrical outlet. Then
position the Vacuum near a drain,
and drain the dirty water using the
Drain Hose (29). (See Figure A.)
12.
the Switch Knob (80) to its “OFF”
position. Then unplug the Wet/Dry
Vacuum from its electrical outlet.
(See Figure A.)
Position the Vacuum near a drain, 13.
and drain the dirty water using the
Drain Hose (29). (See Figure A.)
14.

Cover (9).
(See Figure A, and Assy. Diagram.)
Remove the Foam Filter (85) from 15.
the Filter Cage (84). If necessary,
the Foam Filter may be cleaned with
running water. Then clean and dry
the Tank (35) inside and out.
(See Figure A.)
Replace the Upper Cover (9), and 16.


(See Figure A, and Assy. Diagram.)
Keep the accessories in the 17.
Vacuum’s built-in storage
receptacles, and store the unit in a
clean, dry, safe location out of reach
of children and other unauthorized
people.
REV 10c