Filter
Top Products
4. Operating Instructions 9 1/12/2011 11:51 AM
Operation
DMX Operation
This operating mode will allow for control with an external DMX controller. You must set the
starting address for this mode.
If this is your first time using DMX, then it is recommended that you refer to the “DMX Primer”
section in the “Appendix” of this manual.
Please see the instructions below for details on this mode.
1. Plug the fixture into power.
2. Plug a DMX controller into the fixture in a daisy chain configuration.
3. Press <MODE> until Addr appears on the LED screen.
4. Press <ENTER>.
5. Using <UP> & <DOWN>, select the DMX starting address.
6. Press
<ENTER>
.
DMX Channel Values
CHANNEL
VALUE
FUNCTION
1
000 ó 010
011 ó 045
046 ó 080
081 ó 115
116 ó 150
151 ó 185
186 ó 220
221
ó
255
Pod 1
Blackout
Red
Green
Blue
Yellow
Magenta
Cyan
White
2
000 ó 010
011 ó 045
046 ó 080
081 ó 115
116 ó 150
151 ó 185
186 ó 220
221 ó 255
Pod 2 (run speed when CH.8 is between 011~239)
Blackout
Red
Green
Blue
Yellow
Magenta
Cyan
White
3~6
000 ó 010
011 ó 045
046 ó 080
081 ó 115
116 ó 150
151 ó 185
186 ó 220
221
ó
255
Pod 3~6
Blackout
Red
Green
Blue
Yellow
Magenta
Cyan
White
7
000 ó 009
010 ó 255
Strobe
No function
Strobe
(
slow~fast)
8
000 ó 010
011 ó 047
048 ó 095
096 ó 119
120 ó 144
145 ó 167
168 ó 191
192 ó 215
216 ó 239
240 ó 255
Mode
Individual pod control with strobe (channels 1~7)
Automatic 1
Automatic 2
Automatic 3
Automatic 4
Automatic 5
Automatic 6
Automatic 7
Automatic 8
Sound-active