Operation
-12- Q-Beam 260-LED User Manual Rev. 01d
Continued from previous page
Software Version
1) Go to MENU > INTRO > INFO.
a) The display will show the installed software version.
Range Limitation
1) Go to MENU > RANGE > P/START.
a) Select the starting point for the limited pan (000~255).
2) Go to MENU > RANGE > P/FINISH.
b) Select the finishing point for the limited pan (000~255).
3) Go to MENU > RANGE > T/START.
c) Select the starting point for the limited tilt (000~255).
4) Go to MENU > RANGE > T/FINISH.
d) Select the finishing point for the limited tilt (000~255).
5) Go to MENU > RANGE > USE.
e) Select YES to activate the new settings or NO to stop using them.
Move-in Black
1) Go to MENU > SPECIAL > BLACK.
a) Select YES to enable the 3 seconds delay or NO to make the blackout
immediate.
Reset Control
1) Go to MENU > SPECIAL > RESET.
a) Select DMX to enable the DMX controller to reset the fixture (Control
function) or NO to reset the fixture only from the control panel.
System Default
1) Go to MENU > DEFAULT > DEFAULT.
a) Select YES to default the fixture to its original factory settings.
End of Programming
