Filter
Top Products
Arena Hazer™ 2 User Manual 8 4/20/2010 4:23 PM
3. SETUP
AC Power
This fixture runs on either 115 VAC, 60 Hz, or 230 VAC, 50 Hz. Before powering on the unit, make
sure the line voltage to which you are connecting it is within the range of accepted voltages.
Always connect the fixture to a switched circuit. Never connect the fixture to a rheostat
(variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used only as a 0
to 100% switch.
To determine the power requirements for a particular fixture, see the label affixed to the back plate of
the fixture or refer to the fixture’s specifications chart. A fixture’s listed current rating indicates its
average current draw under normal conditions.
Always connect the fixture to a circuit with a suitable electrical ground.
Breaker Reset
This product is equipped with a breaker on the main power input, located on the exterior of the back panel. In the event
that this breaker trips, you may reset it very easily.
1. Unplug the product from the power outlet.
2. Allow to cool for 5~15 min.
3. Press on the breaker button until it remains in place.
In the event that this breaker will not reset, contact CHAUVET for troubleshooting. The fixture
may need to be serviced.
LED-Illuminated Tank
The fluid tank on this hazer is equipped with LEDs, in order to provide visual fluid level indication, as well as to provide the
readiness of the hazer.
When the color is at red, it means that the hazer is heating. In most circumstances, this will not prevent the hazer from
operating. During operation, the color of the tank will periodically change between blue and red. When initially powering
on the hazer, the tank color will be red. This means that it must heat up to operating temperatures. Once the maximum
operating temperature is reached, the tank color will be blue.
This hazer is designed to work continuously at maximum haze output without the need to wait for the heater to warm up
periodically.
When the tank is empty, the LEDs will flash blue to indicate the auto cut-off feature has been
activated.