Filter
Top Products
WIRELESS PROGRAMING (OPTIONAL ACCESSORIES)
NOTE: Transmitter(s) and wall button supplied with your opener are factory programmed.
INSTALLING YOUR CM128 WIRELESS WALL BUTTON
To install:
•
Carefully pry open the CM128 and locate the two screws for
mounting.
• Attach to the wall using the two screws and wall anchors
provided if mounting to a plaster wall. If using a recessed wall
box do not use anchors.
NOTE: Do not overtighten screws.
+
18
19
10
D
isconnect power to the opener whilst installing
this accessory to prevent accidental activation.
Locate minimum 1.5m above the floor
Activate the opener only when the door is in full view, free of obstruction and properly adjusted.
No one should enter or leave garage whilst the door is in motion. Do not allow children to operate
push button(s) or transmitter(s). Do not allow children to play near the door.
Fix any wall control at a height of at least 1.5m and within sight of the door but away from any
moving parts.
NOTE: The wall control supplied with your opener should be pre-programmed by the factory.
If adding a new wall control, program into the opener before mounting the unit as detailed in section
19.
p
rofessional
LRN
Press LRN
or
LED will FLASH
TO ADD Transmitters / Wireless wall button
Press and hold down the desired
Button.
professional
LRN
Press LRN for 9 seconds
TO DELETE ALL REMOTES
LED on WILL TURN ON
After 9 seconds all remotes
are deleted and LED will go
out.
Release LRN button when
Courtesy LEDs
flashes once
professional
www.chamberlainanz.com
MR850
NOTE: If adding an installed wall control (CM128)
you will need a second person to press and hold
the desired button. If not installed, program the
wall button into the opener before mounting.
ADDING transmitters using the LRN “LEARN”
button
• Press and hold down the button you wish to program
to the opener.
• The orange LED will flash to indicate it is receiving
signal from the transmitter.
• Press and release the “LRN” button.
• The courtesy LEDs will flash once.
• Ensure the door is clear of obstruction, then test the
transmitter.
Deleting ALL transmitter codes
NOTE: This deletes all transmitters and codes
• Press and hold the LRN learn button until the orange
indicator light goes out (approximately 9
sec).