Filter
Top Products
28
TO ADD OR REPROGRAM AN ADDITIONAL HAND-HELD REMOTE CONTROL
PROGRAMMING
TO CONTROL THE OPENER LIGHTS *3-BUTTON REMOTES 315 MHZ
1. Press and release the “learn” button on
the motor unit. The learn indicator light
will glow steadily for 30 seconds.
2. Within 30 seconds, press and hold the
button on the hand-held remote* that
you wish to operate your garage door.
3. Release the button when the motor unit
lights blink. It has learned the code. If
light bulbs are not installed, two clicks
will be heard.
NOTICE: If this Security
✚
®
garage door opener is operated with a non-rolling code transmitter, the technical measure
in the receiver of the garage door opener, which provides security against code-theft devices, will be circumvented. The
owner of the copyright in the garage door opener does not authorize the purchaser or supplier of the non-rolling code
transmitter to circumvent that technical measure.
Your garage door opener has already been programmed at the factory to operate with your hand-held remote control.
The door will open and close when you press the push button.
Using the Multi-Function Door ControlUsing the “Learn” Button
1. Press and hold the button on the
hand-held remote* that you wish to
operate your garage door.
2. While holding the remote button, press
and hold the light button on the
Multi-Function Door Control.
3. Continue holding both buttons while you
press the push bar on the Multi-Function
Door Control (all three buttons are held).
4. Release buttons when the motor unit
lights blink. It has learned the code. If
light bulbs are not installed, two clicks
will be heard.
Only available with Multi-Function Door Control:
In addition to operating the door, you may program the
remote to operate the lights.
1. With the door closed, press and
hold a small remote button that
you want to control the light.
2. Press and hold the Light button on
the Multi-Function door control.
3. While holding the Light button, press and hold the Lock
button on the door control.
4. After the opener lights fl ash, release all buttons.
If provided with your garage door opener, the large button
is factory programmed to operate it. Additional buttons
on any Security✚
®
multi-function remote or mini-remote
can be programmed to
operate other Security✚
®
garage door openers.
Below are instructions for programming your opener to operate with additional Security✚
®
315 MHz remote controls.