Filter
Top Products
16
WRONG
RIGHT
Green
Ground
Screw
Ground
Wire
Ground
Wire
Black
Wire
Black
Wire
Black
Wire
Black
Wire
White Wire
White Wire
Ground
Tab
INSTALLING THE LIGHT BULB(S)
ELECTRICAL REQUIREMENTS
Remove Motor Unit
Screws and Cover
Remove Power Cord
Run Wire from
Outlet to Motor Unit
Replace Motor Unit
Cover and Screws
Flex Sides of Light Lens to
Remove Lens from Tabs
Rotate Light Lens Down Install Standard Light Bulb(s)
(100W max) into Socket(s)
Plug Motor Unit into Power Outlet
If permanent wiring is required by your local code, follow procedure below. Disconnect power to the circuit
before removing cover to establish permanent wiring connections.
To prevent possible SERIOUS INJURY or DEATH from
electrocution or fi re:
• Be sure power is NOT connected to the opener, and
disconnect power to circuit BEFORE removing cover
to establish permanent wiring connection.
• Garage door installation and wiring MUST be in
compliance with ALL local electrical and building
codes.
• NEVER use an extension cord, 2-wire adapter, or
change plug in ANY way to make it fi t outlet. Be sure
the opener is grounded.
NOTE: Plug motor unit into grounded power outlet. If
a grounded outlet is not available, contact a qualifi ed
electrician to install a proper outlet.
To prevent possible OVERHEATING of the endpanel or
light socket:
• DO NOT use short neck or specialty light bulbs.
• DO NOT use halogen bulbs. Use ONLY incandescent.
To prevent damage to the opener:
• DO NOT use bulbs larger than 100W.
• ONLY use A19 size bulbs.
OR
1
1 2 3 4
2 3
100 Watt (Max)
Standard Light Bulb