Filter
Top Products
KG
KG
1
3
9
7
5
1
3
9
7
5
1
2
3
Smart (learn)
Button
SECURITY✚
Garage Door Opener
Indicator
Light
RIGHT
SIDE PANEL
KG
KG
1
3
9
7
5
1
3
9
7
5
1
2
3
33
Figure 2
SECURITY✚
Multi-Function Remote Control
Select a
Push Button
Figure 1
Receiver and Remote Control Programming
Children operating or playing with a garage
door opener can injure themselves or others.
The garage door could close and cause serious
injury or death.
Do not allow children to operate
the door control or remote control transmitter.
A moving garage door could injure or kill
someone under it.
Activate the opener only
when you can see the door clearly, it is free of
obstructions, and is properly adjusted.
WARNING
To comply with FCC rules, adjustment or modification of this receiver and/or
transmitter is prohibited, except for changing the code setting or replacing
the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.
Your garage door opener receiver and remote control
transmitter have been set at the factory to a matching
code. The door will open when you press the LARGE
remote control push button. The code between the
remote control and the receiver changes with each
use, randomly accessing over 100 billion new codes.
Your SECURITY✚ opener will operate with:
• several SECURITY✚ remote controls utilizing up
to 8 functions.
• one Keyless Entry System (with SECURITY✚ logo)
Follow the instructions below to program your opener
to match any additional remotes you may purchase.
See Accessories on page 38.
To Add A Remote Control
If you have a Multi-Function door control:
1.
With the door closed,
press and hold a button on
the remote to be programmed. See Figure 1.
2. Press and hold the Light button on the door control.
3. Press and hold the door control push bar.
4. After the opener lights flash, release all buttons.
Test by pressing the remote push button.
If you do not have a Multi-Function door control:
1.Press and
hold
a button on the remote to be
programmed. See Figure 1.
2.Then press and release the Smart (learn) button on
the right panel of the opener, Figure 2. The
indicator light on the panel will begin to blink and
the opener lights will
flash once.
3. Release the remote push button.
Test by pressing the remote push button.
To Erase All Remote Control Codes
Press and hold the Smart button on the opener for
6 seconds. The indicator light will turn on. Release the
Smart button when it turns off. All codes are now
erased from the opener. Then follow the steps above
to re-program each remote control.
To Control the Opener Lights
With SECURITY✚ transmitters, a remote push button
can be programmed to operate the opener lights
without opening the door.
1.
With the door closed,
press and hold the remote
button that you want to control the light.
2. Press and hold the Light button on the door control.
3. Press and hold the Lock button on the door control.
4. After the opener lights flash, release all buttons.
Test by pressing the remote push button. The opener
lights should turn on or off but the door should not move.
Model 940CB SECURITY✚ Keyless Entry
Follow instructions on page 38 (Accessories).