Filter
Top Products
LOCK
LIGHT
*3-Button Remote Controls
If provided with your
garage door opener, the
large button is factory
programmed to operate it.
Additional buttons on any
Security✚
®
3-Button remote
or mini-remote can be
programmed to operate
other Security✚
®
garage door openers.
To Erase All Codes From Motor Unit
Memory
To deactivate any unwanted remote, first
erase all codes:
Press and hold the “learn” button on
motor unit until the learn indicator light
goes out (approximately 6 seconds). All
previous codes are now erased.
Reprogram each remote or keyless entry you wish to use.
1. Press and hold the button on the hand-
held remote
* that you wish to operate
your garage door.
2. While holding the remote button, press
and hold the LIGHT button on the Multi-
Function Door Control.
3. Continue holding both buttons while you
press the push bar on the Multi-Function
Door Control (all three buttons are held).
4. Release buttons when the motor unit
lights blink. It has learned the code. If
light bulbs are not installed, two clicks
will be heard.
"A"
Button
"B"
Button
To Add or Reprogram a Hand-held Remote Control
USING THE LIGHTED DOOR CONTROL USING THE MULTI-FUNCTION DOOR CONTROL
"A"
Button
"B"
Button
LOCK
LIGHT
LOCK
LIGHT
PROGRAMMING
36
1. Remove the cover from the Lighted
Door Control.
2. Press and hold the button on the hand-
held remote* that you wish to operate
your garage door.
3. While holding the remote button, press
and hold the “A” button on the Lighted
Door Control.
4. Continue holding both buttons while you
press the “B” button on the Lighted Door
Control (all three buttons are held).
5. Release buttons when the motor unit
lights blink. It has learned the code. If
light bulbs are not installed, two clicks
will be heard.
Your garage door opener has already been programmed at the factory to operate with your hand-held remote control.
The door will open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional Security✚
®
remote controls.
NOTICE: If this Security✚
®
garage door opener is operated with a non-rolling code transmitter, the technical measure in
the receiver of the garage door opener, which provides security against code-theft devices, will be circumvented. The
owner of the copyright in the garage door opener does not authorize the purchaser or supplier of the non-rolling code
transmitter to circumvent that technical measure.