Chamberlain 1042 Garage Door Opener User Manual


 
PN# 3642036534, 02/26/2010 REV. 1
16
3.Securely fasten wires.
Securely fasten wires to ceiling and
wall using insulated staples provided.
– Use insulated staples.
– Staples should be snug only.
If rear cover is attached to power head,
remove it.
On power head:
– Route wall console wires through wire guide on
power head.
– Split and strip ends of wire (Fig. 3-2 on
previous page).
Insert wire into terminal holes and lightly press in
the orange locking clips above each terminal
hole. (You can use a pencil or small screwdriver
to comfortably press in locking clips.) The white
wire into #1 terminal hole and striped wire into
the #2 terminal hole.
Confirm wire lock by lightly tugging on the wire.
The wire should remain in the terminal hole.
Do NOT install rear cover yet.
4. Mounting.
Fasten wall console to wall with 2 screws
(provided) (Fig. 3-4).
Remove protective backing from "Entrapment"
warning label (Fig. 3-5). The "Entrapment" label
is located in the center of this manual.
– Stick label on wall near wall console.
Insulated
Staple
+–
PB
Infrared Sensor
123456
FIG. 3-3 Insert wires
.
(Power Head With Rear Cover Removed)
1234
Terminal
Holes
Locking
Clips
56
wire guide
FIG. 3-4 Mounting Wall Console.
Childcanbe pinned under automatic garage
door.
Death or serious injury can result.
Never let child walk or run under moving door.
.
Neve
r let child use door opener controls.
Always
keep movin
g
door in sight.
If person is pinned, push control
button or use
emergency release.
Test door opener monthly:
Refer to your owner s manual
P
lace 1
/-inch object (or 2x4 laid flat) on f
oor
If door fails o reverse on contact adj
ust opener
If
op
ener sti l fails o revers
e d
oor repair
or replace opener
Do not
remove or pa
nt ov
er this label
Mount wa l con rol
ou
t of chi ds reach
(at le
ast
5 fee
t
abov
e floor)
Plac
e next to wal
l
on
trol
©
1999
FIG. 3-5 Mounting Entrapment warning label.
3
2
1
Independent Light Control
Controls door opener lights from inside garage
Energy-Saver shut-off turns OFF lights 3 minutes after
door activation
Vacation Locking Switch
– LOCK disables controls after
door is completely closed
– UNLOCK allows controls to
work normally
Door Control "Open/Close" Button
Open and closes door from
inside garage