Filter
Top Products
25
Stardance Natural Vent Gas Heater
20007067
Optional Accessories Available
Fan Kits
FK26 Fan
The FK26 fan kit helps distribute heated air from within
the firebox out into the room. The fan is controlled by a
snapstat that turns power on and off as the firebox tem-
perature rises above and falls below a preset tempera-
ture. A rheostat provides for variable fan speeds.
Specifications
115 Volt / 60Hz / .75 amps
Maintenance
The fan itself does not require regular maintenance,
however, periodic cleaning of the fan and the surround-
ing area is required.
Installation
Refer to Page 8 for installation instructions.
Remote Controls
The remote control allows you to turn the heater on or
off from anywhere in the room. Refer to Page 21 for
wiring diagrams.
Model Functions Controlled
RC1 ON/OFF
RC2 ON/OFF and Temperature
IMTFK Wall mounted thermostat control
Screen Kit
The S30SK screen kit is designed for use on the Star-
dance Gas Stove with operable doors.
Installation Precautions
Be sure the stove is cool before beginning installation.
WARNING: DO NOT REMOVE GLASS.
Never close the doors with the screen in place. Do-
ing so could cause damage to either the screen or the
doors.
Never handle the screen while the stove is
in operation or when the stove and screen
are hot.
Installation Instructions
To install the screen on the cast front, the operable
doors must be completely open. The doors must remain
in the open position whenever the screen is used.
1. Open the front doors by inserting the handle into the
door latch stub and turn clockwise. (Fig. 42) When
not in use, the handle may be stored in the handle
holder located on the right side of the rear shroud.
(Fig. 44)
ST261
Stardance
operable doors
1/31/01
ST624
handle holder
2/6/01
Clockwise to Open
Counterclockwise
to Close
Handle Holder
ST621/624
Fig. 44 To open doors, insert handle and turn. Store handle
in handle holder.
2. With the doors open, hold the screen at an angle
with the bottom hanger toward the inside. (Fig. 45)
3. Place the hangers on the bottom rib of the front cast
iron frame.
4. Push the top of the screen toward the stove to allow
the spring on the screen to catch at the top of the
stove front.
5. Remove the screen by grasping the handle (only
when cool) and pulling towards you. Then lift to dis
-
engage the hangers.
KT230
Screen install
6/13/01 djt
Glass
Spring
Screen
Bottom
Hangers
KT230
Fig. 45 Hold screen at an angle to attach bottom hangers.