Filter
Top Products
22
FASTENING THE COOKTOP
Each cooktop is provided with an installation kit including brackets and screws for fas-
tening the cooktop to benches from 30 to 40 mm thick.The kit includes two "F" type
brackets (for the front of the cooktop), two "R" type brackets (for the rear of the cook-
top) and four self-threading screws "S" (figs. 21, 22a and 22b).
✓ Cut the unit according to the dimensions in fig. 19.
✓ Turn the hob upside down and rest the glass side on a soft surface.
✓ Spread the seal "G" around the edge of the hob (fig. 21).
✓ Fasten the brackets "F" and "R" to the appropriate socket holes, without tightening
the screws "S" for the moment. Make sure that the tabs are mounted correctly, as
shown. Rotate the tabs so that the cooktop can be put into the cutout.
Figure 22bFigure 22a
3 cm
min
3 cm
4 cm
S
A
R
3 cm
min
A
3 cm
4 cm
F
S
Figure 21
Adhesive side
G
G
✓ Put the cooktop into the cutout and
position it correctly.
✓ Put the brackets "F" and "R" into
place; tooth "A" of the brackets
should go into the hole (Figs. 22a
and 22b).
✓ Tighten screws "S" until the cooktop
is completely secured to the bench.
✓ Using a sharp cutter or trimmer knife,
trim the excess sealing material
around the edge of the cooktop.
Take care not to damage the work-
bench.
REAR FIXING BRACKETS FRONT FIXING BRACKETS