Casio QV-10A Plumbing Product User Manual


 
9
General Precautions
Physical damage and malfunction of this unit can cause the image
data stored in its memory to be deleted. Be sure to always keep
backup copies of data by recording them on video tape or by trans-
ferring them to personal computer memory.
• Never open the battery compartment cover, disconnect the AC
adaptor from the camera or unplug it from the wall socket while the
“WAIT” message is on the LCD. Doing so will not only make storage
of the current image impossible, it can also corrupt other image data
already stored in camera memory.
Liquid Crystal Digital Camera QV-10
10
Other Precautions
MEMORY ERROR message
The following error appears on the built-in monitor whenever the
camera’s flash memory becomes disabled due to malfunction or im-
proper operation.
Whenever this happens, all of the digital images stored in the
camera’s memory will be lost. You will not be able to view stored
images or record new ones. Take your camera to your dealer or an
authorized CASIO service provider as soon as possible after the
MEMORY ERROR message appears.
Operating conditions
This camera is designed for use in temperatures ranging from 0°C
to 40°C (32°F to 104°F).
Do not use or keep the camera in the following areas.
In areas subject to direct sunlight
In areas subject to high humidity or dust
Near air conditioners, heaters, or other areas subject to tem-
perature extremes
Inside of a closed vehicle, especially one parked in the sun
In areas subject to strong vibration
11
Condensation
When you bring the camera indoors on a cold day or otherwise ex-
pose it to a sudden change of temperature, there is the possibility
that condensation can form on the exterior or on interior compo-
nents. Condensation can cause malfunction of the camera, so you
should avoid exposing it to conditions that might cause condensa-
tion.
To keep condensation from forming, place the camera into a plastic
bag before moving it into a location that is much warmer or colder
than your current location. Leave it in the plastic bag until the air
inside the bag has a chance to reach the same temperature as the
new location. If condensation does form, remove the batteries from
the camera and leave the battery compartment cover open for a few
hours.
Other Precautions Liquid Crystal Digital Camera QV-10
12
GUIDELINES LAID DOWN BY FCC RULES FOR USE OF
THIS UNIT IN THE U.S.A. (not applicable to other areas).
Properly shielded cables with ferrite core must be used for connec-
tion to computer in order to meet FCC emission limits.
Caution : Changes or modification to the product not expressly ap-
proved by CASIO could void the user's authority to operate the prod-
uct.
NOTICE
This equipment has been tested and found to comply with the lim-
its for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency en-
ergy and, if not installed and used in accordance with the instruc-
tions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful inter-
ference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following mea-
sures:
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.