Filter
Top Products
4
CTLR-ID — Selecting the Ctlr-ID option from the Program
screen displays the Controller ID screen shown in Fig. 9.
The center portion of the screen shows the following infor-
mation for the controller to which the System Pilot is currently
attached. The controller name, device description, software
part number, reference number, element number, bus number
and baud rate are shown. The device description and reference
number will be truncated, if necessary, to fit on the screen. The
controller name, device description, address and baud rate are
modifiable from security level 1 only.
ALARM HIST — Selecting the ALARM HIST option from
the Program screen displays the Alarm History screen. See
Fig. 10. This screen shows the most recent alarms and alerts
generated by the attached device and stored in its Alarm
History table.
The top line shows the 8-character device name. The middle
of the screen shows the alarms/alerts, displayed one at a time.
The bottom line shows the current alarm number and the
number of alarms in the table. This line may also display error
messages as applicable.
Use the SCROLL UP/DOWN or PAGE UP/DOWN but-
tons or the NAVIGATE knob to scroll through the alarms/alerts
one at a time. If the EXIT button is pressed, the System Pilot
will return to the Program screen.
CONFIG
SETPOINTS
SCHEDULES
ALARM HIST
AT TACH
DETACH
Ctrl-ID
<Controller Name>
<Text & Error messages>
<Controller Name>
<Text & Error messages>
SETPOINTS
ALARM HIST
AT TACH
DETACH
Ctrl-ID
Ctrl-ID
<Controller Name>
ALARM HIST
AT TACH
DETACH
Ctrl-ID
<Text & Error messages>
→ Fig. 6 — Program Screens
Fig. 7 — Attach Screen
(System Pilot on Carrier Communicating Network)
Fig. 8 — Attach Screen
(System Pilot on Local Bus)
Fig. 9 — Controller ID Screen
Fig. 10 — Alarm History Screen
606
→
→