Cadet C Electric Heater User Manual


 
OWNER’S GUIDE
The Com-Pak
Plus
SAVE THESE INSTRUCTIONS
IMPORTANT INSTRUCTIONS
11
1
/2
29.21
3
1
/4
8.26
1
1
/4
3.18
10”
25.4
1
3
/4
4.45
1
1
/4
3.18
7
7
/8
20.00
4”
10.16
3”
7.62
9”
22.86
12”
30.48
10”
25.4
11
1
/8
28.26
12”
30.48
16
1
/4
41.27
The Com-Pak
TM
Plus Model C
The Com-Pak
TM
Twin Plus Model CT
Side Wall Can SideGrill Front
Wall Can Bottom
Side
Wall Can SideGrill Front
TOOLS REQUIRED:
Phillips Screwdriver
Straight Screwdriver
Wire Strippers
Utility Knife
41
1
/2“ Wood Screws
3 Insulated Wire Connectors
1 Strain Relief Connector
WARNING
Turn the electrical power off at the electrical
panel board (circuit breaker or fuse box) and
lock or tag the panel board door to prevent
someone from turning on power while you are
working on the heater. Failure to do so could
result in serious electrical shock, burns, or
possible death.
1. Read all instructions before using this heater.
2. Read all information labels. Verify that the electrical supply
wires are the same voltage as the heater.
3. All electrical work and materials must comply with the National
Electric Code (NEC), the Occupational Safety and Health Act
(OSHA), and all state and local codes.
4. Connect the grounding pigtail (copper wire) provided in the wall
can to the supply ground wire.
5. If you need to install a new circuit or need additional wiring
information, consult a qualified electrician.
6. Protect electrical supply from kinks, sharp objects, oil, grease,
hot surfaces or chemicals.
7. WARNING
Overheating or fire may occur. Do not install the heater in a floor,
behind doors, or outdoors.
8. WARNING
Fire or explosion may occur. Heater has hot and arcing or sparking
parts inside. Do not install heater in any area where combustible
vapors, gases, liquids, or excessive lint or dust are present.
9. WARNING
Burn Hazard. This heater is hot when in use. To avoid burns, do
not let bare skin touch hot surfaces. Use extreme caution when
any heater is used by or near children or invalids and whenever
the heater is left operating unattended.
10. WARNING
Risk of Electrical Shock. Keep all foreign objects out of heater.
Do not operate after heater malfunctions or has been dropped or
damaged in any manner.
11. WARNING
Risk of Fire. Do not block heater. Heater must be kept clear of all
obstructions: a minimum of 3 feet in front, 6 inches above and on
both sides. Heaters must be kept clean of excessive lint, dirt and
debris. (See Maintenance Instructions).
12. Use this heater only as described in this manual. Any other use
not recommended by the manufacturer may cause fire, electrical
shock, or injury to persons.
360-693-2505 Fax: 360-694-8668 P.O. Box 1675 Vancouver, WA 98668-1675
3”
7.62
14
1
/2
36.83
4”
10.16
Features & Benefits
Primary and secondary thermal safeguards
Commercial grade high temperature
manual reset
Over temperature one-time thermal
device
Nichrome element wrapped around mica
insulators for durability
Powder coat paint process eliminates
sharp cutting edges
Two year extended warranty
Wall can designed for ease of installation
Factory tested
MODELS
The Com-Pak
TM
Plus
C051 *C051T C152 *C152T
C052 *C052T C202 *C202T
C072 *C072T C208 *C208T
C102 *C102T C101 *C101T
C122 *C122T C151 *C151T
The Com-Pak
TM
Twin Plus
CT252 *CT252T CT102
CT302 *CT302T
CT402 *CT402T
CT408 *CT408T
*Standard built-in thermostat is single pole and has no
“OFF” position
Wall Can
Bottom