Filter
Top Products
14. Slide the unit back into the fireplace. Check to be sure that the trim panels (and brass) are
properly positioned and lie flat against the front of the fireplace. If panels are out of posi-
tion, slide the unit out and reset by loosening the mounting screws and repositioning in the
slot. With bar, lift stove in front. Place insulation across front and the surface of hearth or
bottom of fireplace, to make complete seal.
15. To check seal of panels, use candle flame and go around the entire area sealed by silicone
and insulation. If flame leans toward inside of fireplace, add additional insulation. This en-
sures an airtight seal.
Final Check
1. Recheck the specified clearances.
2. Remove all foreign material from the firebox area.
3. Open the primary air draft.
NOTE: Plug the power cord into a 115V AC outlet. Set switch to “Manual” and rheostat to
“High” position to ensure motor operates properly. Route the cord to prevent damage to the
cord insulation from heat and sharp objects. Keep the cord out of the way of traffic to prevent
damage caused by tripping, etc.
10