Filter
Top Products
ERROR MESSAGES
Appendix
147
6
■ Alarm
If an incorrect operation is performed, the machine
beeps two or four times.
This message is displayed when
the machine is set for twin needle
sewing and a pattern that cannot
be sewn with the twin needle is
selected.
This message is displayed when
you try to sew with a stitch other
than a middle needle position stitch
while the single-hole needle plate
is installed.
This message is displayed when
the needle plate is removed with
the machine on.
This message is displayed when
the “Start/Stop” button, “Reverse/
Reinforcement Stitch” button, or
the “Thread Cutter” button is
pressed while the presser foot is
raised.
This message is displayed when
the “Start/Stop” button is pressed
while the sewing speed controller
is set to control the zigzag stitch
width.
Memo
To turn the alarm on or off, press .
For details, see page 22.