Filter
Top Products
ERROR MESSAGES
Appendix
145
6
ERROR MESSAGES
If the “Start/Stop button” or the “Reverse/Reinforcement Stitch” button is pressed before the machine is correctly set
up or if an incorrect operation is performed, the machine stops and informs you of the error with an alarm and an
error message. If an error message appears, correct the problem according to the instructions in the message.
(The message that is displayed can be cancelled either by pressing or performing the operation correctly.)
This message is displayed if a
malfunction occurred.
This message is displayed when you
try to use the needle threader lever
while twin needle sewing is set.
This message is displayed when
the upper thread is broken or not
threaded correctly, and the “Start/
Stop” button or the “Reverse/
Reinforcement Stitch” button is
pressed.
This message is displayed when a
buttonhole stitch is selected and
the “Start/Stop” button or the
“Reverse/Reinforcement Stitch”
button is pressed while the
buttonhole lever is raised.
This message is displayed when
the “Start/Stop” button, “Reverse/
Reinforcement Stitch” button,
“Thread Cutter” button or “Presser
Foot Lifter” button is pressed while
the presser foot lever is raised/the
needle is lowered.
This message is displayed when
using USB cable to download
information from PC to machine.
This message is displayed when
the memory is full and the stitch or
pattern cannot be saved.
CAUTION
• Be sure to rethread the machine. If you press the
“Start/Stop” button without rethreading the
machine, the thread tension may be wrong or the
needle may break and cause injury.