Filter
Top Products
5. USING THE OPERATION PANEL (BASIC OPERATIONS)
KE-430F, BE-438F
37
Select the item to be changed.
Press the SELECT key.
The selected parameter changes in the order shown in
the illustration below each time the SELECT key is
pressed.
4
Pattern
Æ
X-scale
Æ
Y-scale
Æ
Sewing speed
Æ
Slow start pattern
Æ
Upper thread tension
5
Change the setting for the parameter.
(Refer to “List of parameters” on the next page for details
on parameter changes. ዅ
Press the
or key to change the parameter
setting.
The flashing display means that the parameter setting
has not yet been applied.
You can make the initial setting appear in the display
by pressing the RESET key.
6
Apply the changed parameter setting.
Press the ENTER key.
The display will change from flashing to illuminated,
and this means that the setting has been applied.
If you press the SELECT key or the TEST key without
pressing the ENTER key, you can cancel the
parameter changes.
7
Repeat steps 4 to 6 above to record the settings for each parameter.
8
If you would like to continue setting another program, repeat steps 2 to 7 above.
9
Exit program mode.
TEST indicator switches off
Press the TEST key.
The display will return to the normal display.
2401B
2402B
2403B
2404B
2382B 2383B