Filter
Top Products
9
SETTING UP YOUR BED FAN
1. Make your bed up with a fitted sheet.
2. Place the Bed Fan Base at or near the foot of your bed with the Air Intake Vent
either facing under, or out from under, your bed.
Important! Make sure nothing is obstructing the Air Intake Vent like a bed
skirt or items stored under the bed.
Note: You may want to take this time to vacuum or dust under your bed,
if needed, to keep the Air Intake Vent from drawing in dust or dirt.
Helpful Hint: If you have a foot board and you are placing the Bed Fan at
the foot of your bed, slide the Air Flow Guide off completely, place the Base
under the bed and slide the Air Flow Guide back on (press the Air Flow Guide
Clips in to slide the Air Flow Guide down) to face the mattress.
3. Slide the Air Flow Guide up or down (press the Air Flow Guide Clips in to slide
the Air Flow Guide down) so that it’s aiming the breeze over the edge of the
mattress towards where your feet will be when you are settled in your bed.
4. Plug the Adapter into the Bed Fan and then into an electrical outlet near the
foot of your bed.
Important: Never place any electrical cord under a rug or carpet.
5. Make your bed up as you normally would, tucking the top sheet in, over and
around the Bed Fan’s Air Flow Guide.
Helpful hint: Sheets with a higher percale count (stitches per inch) allow more
air flow to reach you as the breeze does not escape from in-between the
tighter knit stitches.