Filter
Top Products
Page 10 DPSBSS
Installing "Tee" Connector
The pressure regulator has an outlet pressure of not
more than eleven (11") inches water column. It must
be connected to the propane gas cylinder’s female
valve outlet before the grill and side burner can be
operated.
CAUTION: OPERATION OF A PROPANE GAS GRILL AND
SIDE
BURNER WITHOUT THE PRESSURE REGULATOR AND
HOSE
ASSEMBLY WILL CAUSE GAS LEAKS WHICH COULD
LEAD
TO FIRE OR EXPLOSION, RESULTING IN PROPERTY
DAMAGE
OR PERSONAL INJURY.
The pressure regulator’s fitting must remain clean
and free of nicks and scratches. A dirty, nicked or
scratched fitting can cause a gas leak, resulting in
an explosion or fire. Use only genuine Broilmaster
®
replacement parts unless otherwise specified by the
manufacturer.
Pressure Regulator and
Hose Assembly
If your grill is equipped with a factory installed gas
"tee" behind the grill’s control panel, please skip to
the next section.
Turn OFF the gas valve at the propane cylinder.
Disconnect the regulator and hose assembly from
the cylinder. Disconnect hose from the gas valve
located under the grill’s control panel. F
IGURE 9.
Attach one end of the 10" S/S flex line (22) to the
end of the grill’s gas valve. Attach the other end of
the S/S flex line to the brass "tee" (20). F
IGURE 10.
N
OTE
: G
RILLS
MANUFACTURED
PRIOR
TO
1999
MAY
REQUIRE
THE
ALTERNATE
"
TEE
"
CONNECTOR
.
Installing “Tee” Connector
(Continued)
Attach the regulator and hose assembly to the brass
tee" (20). Reconnect the assembly to the cylinder.
Use two adjustable wrenches to hold and tighten
the joint between the hose and "tee". FIGURE 12.
PROPANE GAS CONNECTION
Connecting to Propane Gas
Attach one end of the 34" S/S flex line (23) to the
end of the side burner valve (6). Attach the remaining
end of the hose to the "tee" (20) and use two
wrenches to tighten the S/S flex line connections.
One wrench should be used to turn the S/S flex line
connector while the "tee" or valve is held with the
second wrench. FIGURE 11.
FIGURE 12
20
FIGURE 10
Grill Gas Valve
"Tee" (20)
10" S/S flex line (22)
FIGURE 9
Grill Gas Valve
Hose Assembly
FIGURE 11
34" S/S flex line (23)
"Tee" (20)
6
For old Broilmaster grill, this alternate tee fitting kit
must be ordered.