5
• DO NOT allow gasoline or other flammable vapors or liquids to come in contact with stove while
lighting or at any time during use of stove.
• DO NOT allow the gas hose to come into contact with any hot surfaces. Inspect the hose for damage
such as burns, chafing, and kinks before each use.
WARNING
READ ALL SAFETY WARNINGS AND INSTRUCTIONS CAREFULLY.
OPERATING INSTRUCTIONS
Step 1
Make sure "Gas Leak Testing" from page 4 was completed
and the burner control knobs are in the "OFF" position and
stove is on a flat surface away from combustible material.
Step 2
Decide which burner to light first. Using a long match,
hold the flame beside burner. Turn the burner control knob
SLOWLY counter-clockwise until the burner lights.
WARNING: If the burner does not light within 5 seconds, turn
the burner control knobs "OFF" immediately. Wait
at least 5 minutes until gas fumes have dissipated
before attempting to light burner again.
Step 3
To light the second burner, reduce the flame on the first lit
burner and repeat Step 2 to the other burner.
WARNING: If second burner does not light within 5 seconds,
turn the burner control knobs "OFF" immediately.
Wait at least 5 minutes until gas fumes have
dissipated before attempting to light burner again.
Step 4
Adjust burner flame as necessary by using burner control
knob. Turn stove "OFF" using burner control knobs when
stove is not in use.
Step 5
Allow stove to cool completely, then follow instructions in
the "After-Use Safety" and "Proper Care & Maintenance"
sections of this manual.
Perimeter of base of stove
OFF / Smaller Flame
ON / Larger Flame
Minimum clearance to
combustibles 36 inches from top
and side of stove burners
NOTE: Observe flame height and
color when lit. Flame
should have a blue center
and yellow tip.
Yellow
Blue
Burner
36"
36"
842-0200-0_Camp Stove-SS.qxd 3/17/03 4:53 PM Page 6