Filter
Top Products
Counter-Clockwise
Attach
Detach
Clockwise
ASSEMBLY INSTRUCTIONS
READ ALL SAFETY WARNINGS & ASSEMBLY INSTRUCTIONS
CAREFULLY BEFORE ASSEMBLING OR OPERATING YOUR STOVE.
Inspect contents of the box to ensure all parts are included and undamaged.
FOR MISSING PARTS, PLEASE CALL CUSTOMER SERVICE AT 1-800-527-0717.
(Proof of purchase will be required.)
3
Step 1
Snap down legs to form a "V" with the stove base.
Step 2
Open lid and align the two wind guards by
inserting notched support arms into wind guards.
Step 3
Remove regulator assembly from under grill
inside stove. Replace grill. Make sure burner con-
trol knobs are in "OFF" position.
Step 4
Attach regulator assembly to stove fitting. HAND
TIGHTEN ONLY. Do not cross-thread connections.
Step 5
Attach propane cylinder to regulator assembly by
turning propane cylinder counter-clockwise.
HAND TIGHTEN ONLY. Do not cross-thread
connections.
CAUTION: Turn cylinder so that it is fully upright. The
cylinder must always sit flat on surface.
See diagram below.
Step 6
Follow "Gas Leak Testing" instructions on page 4
of this manual.
Notched Support Arm
Cooking Grill
Regulator Assembly
WARNING: Always snap down legs to form a "V" with
the stove base to prevent the stove from
becoming unstable while in use.
Burner Control Knobs
NOTE: Propane canister should be
positioned a minimum of 2–3"
from stove. Always use a
canister with a flat bottom.
2–3"
842-0200-0_Camp Stove-SS.qxd 3/17/03 4:53 PM Page 4