Filter
Top Products
SPECIFICATIONS
FREESTANDING:
Width: 22 ½”
Height: 29” (with pedestal), 28 ½” (with legs)
Depth: 27” (excluding ash lip)
Weight: 210 lbs.
Pedestal: 40 lbs.
Legs: 13 lbs.
Flue size: 3” or 4”
Hopper Capacity: Up to 60 lbs.
(this can vary widely depending on pellet size, length, and diameter)
EPA status: exempt
Burn time: 1 lb. to 5 lbs. per hour
BTU range: 8,200 to 47,000
Approved installations: mobile home, alcove, conventional
FIREPLACE INSERT:
Width: 21” (With flashing: 42”)
Height: 20” (With flashing: 30” or 32”)
(depending on which size of flashing used)
Depth: 22 ¾”
In fireplace: 11 ½”
Weight: 185 lbs.
Flashing: 13 lbs.
Flue size: 3” or 4”
Hopper Capacity: Up to 60 lbs.
(this can vary widely depending on pellet size, length, and diameter)
EPA status: exempt
Burn time: 1 lb. to 5 lbs. per hour
BTU range: 8,200 to 47,000
Approved installations: zero-clearance, masonry, as a built-in
PREPARATION
Factory packaging must be removed, and some minor assembly work is required
prior to installation. Access to the rear of the stove is necessary.
The circuit board/control panel must be unpacked and installed in the side flashing
on the insert. (See installation instructions provided with the circuit board)
NOTE: Normally, your dealer will perform these functions.
CLEARANCES
The Breckwell P23 Freestanding has been tested and listed for installation in
residential, mobile home and alcove applications.
The P23 Insert is approved for installation into code complying masonry fireplaces.
The P23 Insert is also approved for use in listed factory built fireplaces (UL 127)
and standard residential built-ins (see As A Built-In Fireplace), including Mobile
Home built-in installations, of the following description: all brands at least 33” wide
and 20 ½” high.
FLOOR PROTECTION: Freestanding installations, minimum 22” wide by 31” deep.
The stove must be placed on a continuous (grouted joints) noncombustible material
such as ceramic tile, cement board, brick, 3/8” millboard or equivalent, or other
approved or listed material suited for floor protection. NOTE: ceramic tile, or any
tile, requires a continuous sheet beneath to prevent the possibility of embers falling
through to the combustible floor if cracks or separation should occur in the finished
surface, this would include floor protection for Built-in raised hearths. Check local
codes for approved alternatives.
Clearances are measured from the sides, back and face (door opening) or stove
body (refer to fig. 4).
DO NOT USE MAKESHIFT MATERIALS OR COMPROMISES IN THE
INSTALLATION OF THIS UNIT.
INSTALL VENT WITH CLEARANCES SPECIFIED BY THE VENT
MANUFACTURER.
FIGURE 2
FIGURE 3
FIGURE 4
INSTALLATION
5
FLOOR PROTECTION
FIGURE 1