Filter
Top Products
TDB3103, WF3203 Installation
8 3-5-08 Bradley Corporation • 215-1332 Rev. T; EN 08-009
Figure 5
3
4
Installing drain spud in bowl
Supply Stop Valve connection,
and P-trap installation
NOTE!
Seal between drain spud and drain hole with
plumber’s putty (supplied by installer).
NOTE!
Fush supply lines before making
connections. Do not use pipe sealant
on compression fittings.
SECURE DRAIN SPUD WITH LOCK NUT AND WASHERS AS
SHOWN IN FIGURE 5.
A
USING PIPE THREAD SEALANT, THREAD SUPPLIED 1/2" STREET ELBOWS
INTO THE 1/2" ANGLE SUPPLY STOPS (SEE FIGURE 9A, PAGE 12)
A
AGAIN USING PIPE THREAD SEALANT, THREAD
SUPPLY STOPS ONTO STUB-OUTS.
B
FOLLOW THE PROCEDURES BELOW AND REFER TO
FIGURE 6 WHEN INSTALLING 3/8" TUBING INTO
SPRAYHEAD TO ENSURE THAT YOU ACHIEVE A
LEAKPROOF SEAL.
C
USING A SHARP KNIFE, CUT TUBING SQUARELY AND
REMOVE ANY BURRS. DO NOT PINCH OR CRUSH END
OF TUBING.
D
LOOSEN NUT ON FITTING. MOISTEN END OF TUBE AND PUSH INTO
FITTING UNTIL IT IS FIRMLY SEATED. TIGHTEN NUT TO SECURE TUBE
TO FITTING (MAKE SURE NUT IS SECURELY TIGHTENED).
E
IF CONNECTOR LEAKS, RESEAT TUBING ACCORDING TO ABOVE
PROCEDURE. IF LEAKING PERSISTS, REPLACE MALE CONNECTOR,
OR CALL YOUR BRADLEY REPRESENTATIVE FOR ASSISTANCE.
F
CONNECT P-TRAP (SUPPLIED BY INSTALLER) TO TAILPIECE AND
DRAIN OUTLET.
G
NUT
TUBING
MALE
3/8" TUBE
CONNECTOR
145-105
SPRAYHEAD
Figure 6
TUBING