Filter
Top Products
Installation TDB3103, WF3203
7Bradley Corporation • 215-1332 Rev. T; EN 08-009 3-5-08
1
2
Rough-in drain & supplies
Bowl/pedestal mounting and assembly
NOTE:
A location to plug in the 24
VAC transformer is required.
Refer to Figure 1c on page 5
for outlet rough-in.
NOTE:
Before attaching 1/4" wing nuts
and washers to threaded rod,
remove red protective caps from
threaded rods. Discard sleeve
caps after removal.
CAUTION:
Bowl surface is smooth.
Aprroximate weight of bowl is 75
pounds. Handle with Care!
ROUGH IN SUPPLY AND DRAIN
PIPING AS REQUIRED FOR YOUR
INSTALLATION (SEE PAGES 5-6
FOR ROUGH-INS OF OPTIONAL
INSTALLATIONS)
A
ATTACH THE STAINLESS STEEL PEDESTAL BASE TO THE PEDESTAL
USING SUPPLIED SCREWS AND FINISHING WASHERS. FOR WALL-
MOUNTED MODELS, SEE PAGES 3-4 FOR PEDESTAL HEIGHT.
A
POSITION THE PEDESTAL AT THE DESIRED LOCATION AND MARK THE
POSITION OF THE (4) PEDESTAL WALL MOUNTING LOCATIONS.
B
SECURE THE PEDESTAL TO THE WALL WITH SUITABLE FASTENERS, 1/2"
ANCHORS AND 1/2" BOLTS (SUPPLIED BY INSTALLER) (SEE FIGURE 1B
FOR WALL MOUNTING LOCATIONS).
C
USING TWO PEOPLE, CAREFULLY LIFT THE BOWL ONTO THE PEDESTAL
(SEE FIGURE 4).
D
POSITION THE BOWL SO THAT THE THREADED RODS IN THE BOWL MATE
WITH THE SLOTTED HOLES IN THE PEDESTAL (SEE FIGURE 4).
E
USING 1/4" WING NUTS AND WASHERS, SECURE THE BOWL TO THE
PEDESTAL, THREE PLACES (SEE FIGURE 4).
F
Figure 4