Bradford-White Corp ACCESSORY MODULE Including Protection, Performance, and Inlet Shut-off Valve Packages Water Heater User Manual


  Open as PDF
of 76
 
Leak Sensor Installation
-46-
Remove the Leak Sensor
Step 13: Remove the Leak Sensor from the water heater jacket, and set it aside. This is shown in Figure
64.
Drill the Leak Sensor Mounting Hole
Step 14: Using a 1/8” drill bit and drill, drill the screw hole that was marked in Step 12. This is shown in
Figure 65.
Figure 64
Figure 65
Leak Sensor
Wire Harness
Leak Sensor
Marked Drill
Location
Drill
 previous next