Filter
Top Products
-7-
,,.<<8;2.<
/*7.A=.7<287,8;-2<
7.,.<<*;B*,8;-@2=1
*-.:>*=.<2C.,87->,=8;<=1*=2<,*9*+5.
8/,*;;B270=1.,>;;.7=7.,.<<*;B/8;B8>;
=885 6><= +. ><.- This will prevent
excessive voltage drop, loss of power or
overheating. Grounded tools must use 3-wire
extension cords that have 3-prong plugs and
receptacles.
#The smaller the gauge number, the
heav i er the cord.
!")"'#"!"
%##!#$!!##"
!
WARNING
#885E<
69.;.
!*=270
8;-"2C.27&
&2;."2C.<2766
3-6
6-8
8-10
10-12
12-16
18 16 16 14 0.75 0.75 1.5 2.5
18 16 14 12 0.75 1.0 2.5 4.0
18 16 14 12 0.75 1.0 2.5 4.0
16 16 14 12 1.0 2.5 4.0 —
14 12 —— ————
25 50 100 150 15 30 60 120
8;-.70=127..= 8;-.70=127.=.;<
*27=.7*7,.
".;?2,.
$"!"!%
!#"" ;.?.7=2?.
6*27=.7*7,.9.;/8;6.-+B>7*>=18;2C.-
9.;<877.56*B;.<>5=2762<95*,2708/
27=.;7*5@2;.<*7-,86987.7=<@12,1
,8>5-,*><.<.;28><1*C*;- We recom -
mend that all tool service be performed by a
Bosch Factory Service Center or Authorized
Bosch Service Station. SERVICE MEN:
Disconnect tool and/or charger from power
source before servicing.
##!"
.*5.;=/8;+*==.;B9*,4<=1*=*;.7.*;270
=1.2;.7-8/52/. If you notice decreased
tool performance or significantly shorter
running time between charges then it is time
to replace the battery pack. Failure to do so
can cause the tool to operate improperly or
damage the charger.
5.*7270
#8*?82-*,,2-.7=<*5@*B<
-2<,877.,==1.=885*7-8;
,1*;0.;/;86=1.98@.;<>995B+./8;.
,5.*7270 The tool may be cleaned most
effectively with com pressed dry air. 5@*B<
@.*;<*/.=B08005.<@1.7,5.*7270=885<
@2=1,869;.<<.-*2;
.;=*27,5.*7270*0.7=<
*7- <85?.7=< -*6*0.
95*<=2,9*;=< Some of these are: gasoline,
car bon tetrachloride, chlorinated cleaning
solvents, ammonia and household detergents
that contain ammonia.
!
WARNING
!
WARNING
!
CAUTION
# This equipment has been tested and
found to comply with the limits for a Class B
digital devices, pursuant to Part 15 of the FCC
rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates uses and can radiate
radio frequency energy and, if not installed and
used in accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user
is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
BM 2610022017 04-12_BM 2610022017 04-12.qxp 4/17/12 12:45 PM Page 7