Filter
Top Products
!!#!""("
If the indicator lights are “OFF”, the charger is
not receiving power from power supply outlet.
If the green indicator light is
“ON”, the charger is plugged in
but the battery pack is not
inserted, or the battery pack is fully charged
and is being trickle charged.
If the green indicator light is
“BLINKING”, the battery pack is
being fast-charged. Fast-
charging will automatically stop when the
battery pack is fully charged.
!##!#"
1. The charger was designed to fast charge
the battery only when the battery temperature
is between 32˚F (0˚C) and 113˚F (45˚C). If the
battery pack is too hot or too cold, the charger
will not fast charge the battery. (This may
happen if the battery pack is hot from heavy
use). When the battery temperature returns to
between 32˚F (0˚C) and 113˚F (45˚C), the
charger will automatically begin charging.
2. A substantial drop in operating time per
charge may mean that the battery pack is
nearing the end of its life and should be
replaced.
3. Remember to unplug charger during storage
period.
4. If battery does not charge properly:
a. Check for voltage at outlet by plugging in
some other electrical device.
b. Check to see if outlet is connected to a
light switch which turns power “off” when lights
are turned off.
c. Check battery pack terminals for dirt.
Clean with cotton swab and alcohol if
necessary.
d. If you still do not get proper charging,
take or send tool, battery pack and charger to
your local Bosch Service Center. See “Tools,
Electric” in the Yellow Pages for names and
addresses.
8=. Use of chargers or battery packs not
sold by Bosch will void the warranty.
-5-
<<.6+5B
9.;*=2707<=;>,=287<
!##"#
"!
The lithium ion battery is protected against
deep discharging by the “Electronic Cell
Protection (ECP)”. When the battery is empty,
the cordless worklight is switched off by means
of a protective circuit.
#$!#&!#
1. To turn the Flashlight "ON", press the On/Off
switch. To turn Flashlight "OFF", press the
On/Off switch (Fig. 1).
Do not continue to press the
On/Off switch after the
cordless worklight has been automatically
switched off. The battery can be damaged.
!
CAUTION
"!#!"
##!(
To insert battery, align battery and slide
battery pack into tool until it locks into position.
Do not force.
Release battery pack from tool by pressing on
both sides of the battery release tabs and pull
downward (Fig. 1).
#8;.->,.=1.;2<48/.5.,=;2,<18,4-2<,877.,=+*==.;B9*,4+./8;.
,5.*72708;<.;?2,270
!
WARNING
BM 2610022017 04-12_BM 2610022017 04-12.qxp 4/17/12 12:45 PM Page 5