Filter
Top Products
WZ16 Integrated IR Bullet Camera Safety | en 5
18. These servicing instructions are for use by qualied service personnel only. To
reduce the risk of electric shock, do not perform any servicing other than that
contained in the operating instructions, unless you are qualied to do so.
1.3 Important Notices
Accessories - Do not place this unit on an unstable stand, tripod, bracket, or mount. The
unit may fall, causing serious injury and/or serious damage to the unit. Use only with
the cart, stand, tripod, bracket, or table specied by the manufacturer. When a cart is
used, use caution and care when moving the cart/apparatus combination to avoid injury
from tip-over. Quick stops, excessive force, or uneven surfaces may cause the cart/unit
combination to overturn. Mount the unit per the manufacturer’s instructions.
All-pole power switch - Incorporate an all-pole power switch, with a contact separation
of at least 3 mm in each pole, into the electrical installation of the building. If it is
needed to open the housing for servicing and/or other activities, use this all-pole switch
as the main disconnect device for switching off the voltage to the unit.
Camera grounding - For mounting the camera in potentially damp environments, ensure
to ground the system using the ground connection of the power supply connector (see
section: Connecting external power supply).
Camera lens - An assembled camera lens in the outdoor housing must comply and be
tested in accordance with UL/IEC60065. Any output or signal lines from the camera must
be SELV or Limited Power Source. For safety reasons the environmental specication of
the camera lens assembly must be within the environmental specication of -10 °C to
50 °C (14 °F to 122 °F). Camera signal - Protect the cable with a primary protector if the
camera signal is beyond 140 feet, in accordance with NEC800 (CEC Section 60).
Camera signal - Protect the cable with a primary protector if the camera signal is beyond
140 feet, in accordance with NEC800 (CEC Section 60).
Coax grounding:
– Ground the cable system if connecting an outside cable system to the unit.
– Connect outdoor equipment to the unit’s inputs only after this unit has had its
grounding plug connected to a grounded outlet or its ground terminal is properly
connected to a ground source.
– Disconnect the unit’s input connectors from outdoor equipment before
disconnecting the grounding plug or grounding terminal.
– Follow proper safety precautions such as grounding for any outdoor device
connected to this unit.
U.S.A. models only - Section 810 of the National Electrical Code, ANSI/NFPA No.70,
provides information regarding proper grounding of the mount and supporting structure,
grounding of the coax to a discharge unit, size of grounding conductors, location of
discharge unit, connection to grounding electrodes, and requirements for the grounding
electrode.
Disposal - Your Bosch product was developed and manufactured with high-quality
material and components that can be recycled and reused. This symbol means that
electronic and electrical appliances, which have reached the end of their working life,
must be collected and disposed of separately from household waste material. Separate
collecting systems are usually in place for disused electronic and electrical products.
Please dispose of these units at an environmentally compatible recycling facility, per
European Directive 2002/96/EC.
Electronic Surveillance - This device is intended for use in public areas only. U.S. federal
law strictly prohibits surreptitious recording of oral communications.
Environmental statement - Bosch has a strong commitment towards the environment.
This unit has been designed to respect the environment as much as possible.
Bosch Security Systems, Inc. Installation Manual | 1.0 | 2010.12