Filter
Top Products
UHI-SBG-0 Series Mounting the Housing | en 13
Bosch Security Systems, Inc. Installation Manual September 15, 2006 | F01U032279_01
6 Mounting the Housing
The UHI-SBG-0 housing includes a J-mount which features a removable camera bracket and
locking grooves to keep the housing from drooping. The mount is vertically adjustable by
pushing the housing up or down.
Mounting Procedure
1. Determine a proper location for the housing.
2. Insert the coax and power lead wires from the wall through the supplied J-mount allow-
ing enough slack to pull through the housing (see Figure 6.1 on page 13 if using the bot-
tom glands or see Figure 6.2 on page 13 if using the rear glands).
.
Fig. 6.1 Feeding the Wire using the Bottom NPT Fittings
Fig. 6.2 Feeding the Wire using the Rear NPT Fittings
3. Prepare the surface for mounting and install the J-mount.
Fig. 6.3 Mounting the J-mount and Housing
4. Place the UHI-SBG-0 housing on top of the J-mount while feeding the wires through the
bottom or rear NPT fittings.
5. Make sure that the weight of the camera is distributed evenly.