Filter
Top Products
D9000,G & GV2 Series | Owner's Manual Supplement
Bosch Security Systems | 5/05 | 33267F 13
10.3 Cycle Door?
1. To momentarily unlock an access door and allow a person into an
area, press [ENT] at the Cycle Door? prompt.
The display shows CYCLE 1 2 3 4 5 6 7 8 if all doors are in
a normal state and available. If a door is not in a normal state, the
number of the door is replaced with one of the symbols indicated
in Table 1.
Table 1: Key to Symbols
Symbol Description
---
Door is not active, not in scope, or user does
not have access level authority
C
Door is timed door sequence
U
Strike and shunt are latched active (held open)
X
Strike and shunt are deactivated (secured)
P There is a problem with the door; call your
security company
2. Enter the number of the door to cycle then press [ENT]. This
door cycles and the display changes to reflect the new status of
the doors. For example, to cycle Door 3, at the following prompt:
CYCLE DOOR 1 2 3 4 5 6 7 8
press [3], then [ENT]. The display shows:
CYCLE DOOR 1 2 C 4 5 6 7 8
This indicates that all doors are in a normal state, except for Door
3, which is cycled.
3. Press [ESC] to leave this subfunction, or enter another door
number to cycle.