Filter
Top Products
PAGE 1 OF 9
Security Systems
Addendum
DVR670 Installation and Operation manual AM18-Q0617
Security Warning
The remote system access feature, designed to allow users to view their video via a PC or phone, may
compromise their security devices and expose them to malicious use.
To avoid putting your devices and personal information at risk, always consult your network specialist for advice
on network security infrastructure (i.e. MAC filtering, Access Control List).
Bosch accepts no responsibility for possible damage caused by unauthorised access.
iPhone ‘DVR Viewer’ APP
With firmware v2.1.x the iPhone ‘DVR Viewer’ APP version 1.0.3 or higher must be used.
IP camera integration from firmware v2.1 onwards
Introduction
This addendum describes how to integrate an IP camera in the DVR 670 Series (firmware 2.1 onwards).
The main requirements and restrictions are:
• Input from a maximum 4 SD Bosch IP cameras can be recorded on a single DVR 670. Using IP cameras
means the DVR can manage fewer analog cameras; i.e. if you connect 1 SD camera, you will lose 1 analog
camera.
• The DVR does not directly control the camera stream (IPS or resolution) and will only record the available
stream (configured on the camera).
• Event triggered recording (motion and/or input) is not supported for the connected IP cameras.
• Live and playback video of connected IP cameras (SD streams) can be shown on a local DVR monitor A.
• Viewing of IP camera on Mon. B is not supported.
• Video of connected IP camera can also be shown via Web pages and supported PC applications.
• PTZ and fixed SD cameras can be recorded, however only standard PTZ commands and presets (go to, set,
clear) are available (i.e. there is no AUX, iris and focus control). To enable PTZ for IP cameras please select
RS232 or RS485 PTZ communication protocol for the selected channel.
• Supported resolutions :
IPS
Resolution
NTSC
≤ 30 IPS
≤ 702 x 576 (SD/D1/4CIF)
PAL
≤ 25 IPS
≤ 702 x 480 (SD/D1/4CIF)