Filter
Top Products
38 en | Subsystem Maintenance and Upgrading RAID Subsystem DVA-12T | Installation Manual
F.01U.027.798 | V1 | 2006.06 Bosch Security Systems
Fig. 6.6 PSU Parts Identification
Fig. 6.7 Removing the PSU Retention Screw
2. Once the power switch has been turned off, remove the power cable that connects the
RAID subsystem to the main power. The power cable socket is found on the left-hand
side of the module.
3. After the power cable has been removed from the socket, remove the retention screw at
the top right-hand side of the PSU. (See Figure 6.8).
4. Remove the PSU module. Push the extraction lever at the back of the PSU module down-
wards. This will dislodge the PSU module from the subsystem. Once dislodged gently pull
the PSU module out of the subsystem. (See Figure 6.8).
Fig. 6.8 Removing the PSU Module
5. Remove the cooling module. To do this, push the clips on either side of the cooling mod-
ule rear panel together. Then gently pull the cooling module out of the lower level of the
PSU bracket. (See Figure 6.9)