Filter
Top Products
D1260/D1260B | Owner's Manual | Part III: Advanced Commands - DEFAULT TEXT ? (COMMAND + 5 + 7)
60 Bosch Security Systems | 9/04 | 50410D
5. If the card you are trying to add to the system
already exists, an error tone sounds and the display
changes to
Card already exists. Please try again.
If 20 seconds elapse without pressing a key returns
the display to idle text. Pressing the
<Exit
soft key
exits out of this function and returns the display to
the main
Add / Change User
display.
Then the display returns to
Present card to card
reader now.
Present the card to the reader to continue or press
the
<Exit
soft key to exit out of this function and
return the display to idle text.
6. If the card is accepted, the display changes to
either
Card added.
or
Card changed
if the card
already exists in your system.
Pressing the
<Exit
soft key exits out of this
function and returns the display to the main
Add /
Change User
display.
Pressing the
Next>
soft key exits out of this
function and returns the display to Add/Change
Passcode depending on if a passcode already exists
for the user.
DEFAULT TEXT ? (COMMAND + 5 + 7)
This function allows the current state of the area for 3
seconds before returning to idle text.
1. Ensure your keypad shows idle disarmed text.
2. Press the COMMAND key. The display shows
*System Command*
.
3. Press the 5 key and then the 7 key.
If you prefer, you may use the Command
Menu in place of steps 2 and 3 to initiate
this function.
Press the MENU> soft key to enter the
Command Menu.
Press NEXT> soft key repeatedly.
When you reach the DEFAULT TEXT ?>
prompt, press its adjacent soft key.