Filter
Top Products
en
| 3
Bosch Security Systems
| April 03 | 3922 988 97112 en
Digital Congress Network
| TCB 4 Upgrade Kit LBB 3519/20 | Chapter 1. Upgrade Kit LBB 3519/20
Chapter 1. Upgrade Kit LBB 3519/20
Introduction
The upgrade kit LBB 3519/20 is intended for upgrading of the following DCN Central
Control Units:
• LBB 3500/00 (D)
• LBB 3500/10 (D)
• LBB 3500/30 (D)
The upgrade kit LBB 3519/20 (Trunk Communication Board (TCB 4)) once installed
in the Central Control Units provides the CCUs’ with a high speed serial RS 232
port. This port can be used for either ‘DIRECT’ connection to a DCN control PC,
camera control, test/diagnostic purposes or for remote control.
The TCB4 has two Ports, Port 1 and Port 2. Both Ports can be used if a second hole is
made at the rear of the CCU housing to accommodate the second 9-pole D-type
connector.
NOTE:
If a second port is required, then an additional interconnection cable is
also required. This cable is ordered separately under Code No. 3922 156
24090, through your local Bosch supplier.
REMARKS:
1. Using the ‘DIRECT’ connection method the PC-Network card LBB 3510/00 is
NO longer required.
2. If a
‘DIRECT’
connection is made between the Control PC and the CCU, the PC
operator has no connection to the PC for headphone or intercom handset. Additional
DCN hardware is required for the operator if these functions are required. Use can be
made of DCN table-top or flush-mounted hardware depending on the requirements.
FIGURE 1-1 CCU upgrade kit LBB 3519/20
LBB 3500/xx (also applicable for LBB 3500/10)
LBB 3500/xx
LBB 3500/xx (with upgrade)
LBB 3500/xx (with upgrade)
Two ports
Port 1 - ‘DIRECT’ connection to DCN control PC (default) (see Note)
Port 2 - Automatic camera control (default) (see Note )
Single port only (Port 1)
TCB 2 or 3
TCB 4
TCB 2 or 3
TCB 4
NOTE: The default settings for Port 1 can be changed to suit
your requirements (see Chapter 3).
NOTE: The default settings for Port 1 and 2 can be changed to
suit your requirements (see Chapter 3.).